eChapters

Family: Brassicaceae

Flowering: June-August

Fruiting: August-October

Botanical description: The plant is an annual herb that reaches at a height upto 2 ft, with many branches on the upper part. The leaves are entire, the upper ones are stalkless whereas the lower ones are stalked. Flowers are white to pinkish in color, small, 2 mm across, borne in long racemes. The fruits are small pods, obovate, with two seeds per pod. The seeds are brownish red in colour and become slimy when soaked in water. Garden cress is native to mediterranean region, introduced and naturalised, cultivated throughout the world. Within India, it is cultivated as a salad plant and found as an escape.

SCARs are DNA fragments amplified by the Polymerase Chain Reaction (PCR) using specific 15-30 bp primers, designed from nucleotide sequences established in cloned RAPD (Random Amplified Polymorphic DNA) fragments linked to a trait of interest. By using longer PCR primers, SCARs do not face the problem of low reproducibility generally encountered with RAPDs. Obtaining a codominant marker may be an additional advantage of converting RAPDs into SCARs. However, SCARs may exhibit dominance when one or both primers partially overlap the site of sequence variation. SCARs are locus specific and have been widely applied in gene mapping studies and marker assisted selection (Paran & Michelmore, 1993).

Waldhemia glabra (Decne.) Regel. (Asteraceae): Eng.- Smooth Ground Daisy [W] A tufted mat forming, aromatic high altitude plant of drier areas of Kashmir Himalaya at 4000-5000 m altitudes. Leaves wedge shaped and bluntly 3-5 lobed, occur in rosettes. Flower heads solitary on stems, pink to purple ray florets, disc florets yellow. Whole plant used for rheumatism.

Introduction

The Over-head insulator for overhead lines provides insulation to the electrical conductor. It is connected to the cross arm of the supporting structure and the electrical conductor passes through the clamp (insulator). It is mainly made of either glazed porcelain (Silica 20% + Feldspar 30% + Clay 50%) or toughened glass. The porcelain must be free from any defect. It should be vitrified because the presence of pore or air will lower down its dielectric strength. Any captured air impurity will also reduce the dielectric strength of the porcelain. Therefore, it is highly desirable that the insulators should be air free and resistant to the entrance of liquids/gases. It is desirable not to allow porcelain to come in direct contact with a hard metal screw thread. Therefore, cement is used between metal and the porcelain.

1. Technical Feasibility of Dairy Unit

This includes following information such as
 
    1.    Availability of good quality animals in nearby dairy market,
 
    2.    Availability of good grazing grounds and lands,
 
    3.    Availability of green/dry fodder,
 
    4.    Availability of concentrate feed, medicines etc.
 
    5.    Further availability of veterinary aid, dairy breeding (AI) centre, milk collection and marketing centre are also important.

    6.    Nearness of the selected area to veterinary/breeding/milk collection centre and the financing bank’s branch.

    7.    Capability of the owner and employees such as technical knowledge and skill.

Patients are unable to consume foods and fluids orally when they are suffering fromillness. Under surgical conditions, severe burns, severe infectious neonatal infants, congenital anomalies, anorexia, coma or dysfunction of elementary tract etc., special feeding methods should be used for feeding such patients.

Objectives

• To provide water and electrolytes to prevent dehydration and correct electrolyte imbalance.

• To make up the loss of tissue protein.

• To provide energy to meet the daily needs of the patients.

The nutrients used in intravenous feeding are :

a) Water and electrolytes : The daily minimum water requirement of an adult on anaverage is 1.5 liters.Additional waterwillbe requiredto correct dehydration that might have occurred before therapy. The water loss made up in about 24 hour and the urinary excretion restored to about 300-400 ml in every 8 hrs.

b) Carbohydrates and alcohol : Glucose, Fructose and Sorbitol are used in intravenous feeding. Three per cent alcohol @ 8 g/h can also be given; because this provides 7.1 kcal energy/ g. Glucose is usuallyadministered as 5 % solution. Fructoseis preferred to Glucose, as it can be administered at a concentration of 10-15 % without any adverse effect.

c) Amino acids : Solution form of Protein hydrolysates, Synthetic amino acid mixture and a mixture of L-amino acids are available for intravenous feeding. Protein hydrolysates prepared from casein, free from peptides and fortified withTryptophan are commonlyusedfor intravenous therapy.

d) Whole blood or plasma : One litre of whole blood provides about 180 gm proteins including haemoglobin. Blood is used mainly to combat circulatoryfailure andloss of bloodfrombody. One liter of plasma contain about 60-70 gm of protein. Plasma infusion is given as a measure for increasing plasma protein level when it is low.

e) Vitamins: All the vitamins (twice daily requirements) should be added to intravenous fluid to meet the daily needs of the patient.

X-efficiency : Producing output at the minimum possible cost. This is not enough to ensure the best sort of economic efficiency, which maximises society’s total consumer plus producer surplus, because the quantity of output produced may not be ideal. For instance, a monopoly can be an X-efficient producer, but in order to maximise its profit it may produce a different quantity of output than there would be in a surplus-maximising market with perfect competition.

Family: Lamiaceae

Flowering: July-October

Fruiting: October-January

Botanical description: The plant is an erect and diffusely branched annual herb, growing up to 20-60 cm in height. Leaves are linear or oblong, 2.5 to 7.5 cm long with blunt tips and scalloped margins. Whorls are large, terminal and axillary, about 2.5 cm in diameter and crowded with white bell shaped flowers. Calyx is variable, with an upper lip and short, triangular teeth. Nutlets are 2.5mm in size, smooth and brown.

Synonym : PCR-RFLP (PCR- Restriction Fragment Length Polymorphism)

The Cleaved Amplified Polymorphic Sequence or CAPS method is a technique in molecular biology for the analysis of genetic markers. It is an extension to the Restriction Fragment Length Polymorphism (RFLP) method, using polymerase chain reaction (PCR) to more quickly analyse the results.

Like RFLP, CAPS works on the principle that genetic differences between individuals can create or abolish restriction endonuclease restriction sites, and that these differences can be detected in the resulting DNA fragment length after digestion.

In the CAPS method, PCR amplification is directed across the altered restriction site, and the products digested with the restriction enzyme. When fractionated by agarose or acrylamide gel electrophoresis, the digested PCR products will give readily distinguishable patterns of bands. Alternatively, the amplified segment can by analyzed by Allele specific oligonucleotide (ASO) probes, a process that can often be done by a simple Dot blot.

Xanthium strumarium L. (Asteraceae): Eng.- Common Cocklebur; Kash.- Tcheere [W]. An annual herb usually inhabiting disturbed soils. Leaves simple, alternate. Flower heads are borne in leaf axils and have disc florets only.

Cytology is the study of cells from fluid or tissue samples prepared directly on glass slides and stained for microscopic evaluation. It is also described as examination of cells without regard to the tissue's architectural details.

It is less invasive than tissue biopsies and, in some cases, it can provide a rapid diagnosis that would otherwise take several days if done by histopathology.

When is the cytology needed?

The diagnostic methods of clinical examination, radiographic evaluation, and laboratory data suggested that a diagnosis that cannot be confirmed by these methods. In that situation, cytology is very much helpful to confirm the disease processes or conditions.

Years of potential life lost : A measure of the impact of premature mortality on a population, calculated as the sum of the differences between some predetermined minimum or desired life span and the age of death for individuals who died earlier than that predetermined age.

India is endowed with abundant natural resources and diverse agroclimatic conditions, which are ideal for cultivation of a number of annual or perennial crops, in different areas. Meticulous planning, extraordinary scientific support, judicious use of inputs and focused policy thrust have led to manifold increase in production and productivity of fruit trees. The horticultural crops, particularly fruit crops, are high-value and technology- intensive crops. Appropriate technologies are gaining popularity in entire country in view of their high potential of productivity, land utilization and more income. Today, our country is producing different kinds of fruits, but quantum of total fruit production is unable to cope with the present day demand. Various constraints, biotic and abiotic in nature, pose hindrances to meet the fuel potential. The poor productivity of fruit trees is the main reason of low availability of fruits. The low productivity of fruits is compounded by several environmental, genetic and conditional factors. Besides, productivity and quality of perennial fruits continued to remain low and there exists a wide gap in between actual and potential production. Visualizing the problems of perennial commercial fruit production, the main reason comes in forefront/top is a large number of old and senile orchards turning even unproductive, due to lack of information regarding non-adoption of appropriate agro-techniques and canopy management (Hare Krishna, 2012). Though, we have made rapid strides in fruit production, the productivity is very low compared to developed countries. The present scenario of production in our country is still technology deficit and what so ever the technologies are available very poor in adoption level and the situation still go worse even in the era of climate change.

Present situation demands that new technologies are needed to push the yield frontiers further by utilizing inputs more efficiently, diversifying to more sustainable and yielding higher quantum of quality production, particularly by integration of invasive and non-invasive medium-term strategic technologies. There are still challenges ahead in the way of the research which require concerted efforts in organizing, conducting and developing the technology as well as the proper way they are transferred to growers. The new generation of technologies will have to be much more site-specific, based on high quality science and a heightened opportunity for end-users, participation/adoption in identification of targets and achieving the objectives. These must be not only aimed at increasing the growers/farmers technical knowledge and understanding of science-based timely operations. It will also need to take on challenges of integrating the socio-economic context and role of markets for profitability and economic viability.

Family: Plantaginaceae

Flowering: September-November

Fruiting: December-February

Botanical description: The plant is a perennial, small marsh herb. Stems are much branched, hairless. The aerial stems are up to 15 cm height, simple or branched, hairless, with stalked or stalkless glands. The submerged leaves are 1.5-2.5 cm in size, pinnately cut into segments which are flattened to capillary. The aerial leaves are usually whorled, pinnately lobed, 0.4-2 cm, sometimes few opposite and toothed. Flowers arise singly in the axils of aerial leaves. Flower stalk is slender, and 2-10 mm in length. Petals are botched with dark purple or reddish spots. The capsule is dark brown, compressed with ellipsoid to round in shape.

The inoculum dosage and method of application determines the efficacy of biofertilizers. The quantity of biofertilizers to be applied depends on the type of crop, seed rate and soil edaphic factors. There are 3 methods for inoculation of biofertilizers

Seed treatment: One packet containing inoculant (200 g) is mixed with 200 ml of rice gruel or 40 % gum arabic solution to make a slurry (Fig. 23). Then the seeds required for an acre are mixed in the slurry in such a manner that they have a uniform coating of the inoculant over the seeds. Then, the inoculated seeds are shade dried for 30 minutes. The shade dried seeds should be sown within 24 hours. One packet of the inoculant (200 g) is normally sufficient to treat 10 kg of seeds.

Youngia tenuifolia (Willd.) Babc. & Stebb. (Asteraceae): Ladakhi– Neu [W]. A perennial herb of high altitude cold arid areas.

The Feasibility study of dairy project cover capital investment on land, building, infrastructure, working capital, manufacturing and marketing cost, and financial projections to work out its viability. Once viability is established, a detailed project report should include the following ten steps for project planning and implementation:

First Step: This step involves appointing a consultant to plan the project in relation to the design the dairy plant, proposed market and select an architect and a structural consultant. Prepare tender documents for civil works and plant equipment. Study the demand-supply of target products through a market survey to formulate the suitable product mix in terms of volume and range. e.g. study of various dairy products e.g. Khoa, ghee, Ice cream. The capacity of the plant and the provision of various facilities would be determined by the products demand.

Zero-sum game : When the gains made by winners in an economic transaction equal the losses suffered by the losers.

Today, our country is the second largest producer of fruits in the world, yet the per caput availability of fruits is below the recommended level (Chadha et al., 2013). The major reason for low availability of fruits is poor productivity. In addition, pressure of burgeoning population and ever increasing demand also result in reduced availability of fruits. The production of fruit crops is still nature dependent. The problem of low productivity of fruits is compounded by several environmental, genetic and conditional factors. At present, there exist a wide gap in between actual fruit yield and their potential yield in almost all tropical and subtropical fruit species, particularly in perennial and woody trees of fruits.

There is a great diversity in perennial fruit crops which permits considerable manipulation for various purposes and desirable outcome. For achieving even the average productivity in many fruit crops, the production constraints like lack of information regarding canopy management, non-adoption of appropriate agro-techniques and timely management practices are required, while the concern about existing a large number of old and senile orchards which has turned or are turning even unproductive needs attention (Hare Krishna, 2012). Though, the country’s fruit production status is showing an increase, but far below the potential production requires immediate attention to critically analyze the situation by revisiting the problems and its causes, identifying the gaps and development of need- based technologies in the present context.

Family: Marsileaceae (Pteridophyta)

Flowering: November-January

Fruiting: January-March

Botanical description: The plant is a branched herbaceous plant with creeping rhizome and usually 3-15 cm or more in length. Leaves are composed of 4 obdeltoid leaflets. Leaflets are cruciform, obovate, variable in size depending on the ecological conditions, usually glabrous with rounded outer margin. Pedicels are 2-6, basal and slightly connate or free. Sporocarps are seen crowded or in groups of 2–3, arising at the base of the petiole.