eChapters

Pollution is the term used to denote the hindrances caused to living organisms by way of contamination of their physical environment. Pollution to air, water, soil etc. is the major problem faced by the living community. Measures to control the emission of pollution into air, water or soil will certainly reduce the level of pollutants. Mitigation of pollution can be best achieved by combining nature with technology that increases the effectiveness of plants in removing pollution. Use of vegetation is an effective means of pollution control and many researchers have reported their advantages in mitigating pollution.

So far, the main approach has been to dig the polluting chemicals out of the ground and transport them to a landfill. However, after a decade of research, scientists in the early twenty-first century found that hundreds of species of plants, along with the fungi and bacteria that inhabit the ecosystem around their roots, seek out and often break down chemical molecules that can harm most other life.

In the mid-1980s, Dr. B.C. Wolverton and fellow researchers at NASA conducted several studies to determine whether plants could halt indoor pollution and provide a natural way to deal with the problem. It has been suggested by NASA and the Associated Landscape Contractors of America (ALCA) that plants are major pollution-absorbing devices: the common indoor plants might provide a natural way of helping combat “SICK BUILDING SYNDROME”. Common indoor plants may provide a valuable weapon in the fight against rising levels of indoor air pollution. These plants are not only decorative, but are also surprisingly useful in absorbing potentially harmful gases and cleaning the air inside modern buildings.

The biosecurity risk assessment informs the biosecurity plan, which documents the mitigation measures put in place to address risks. Risks that fall outside of the risk tolerance threshold should be controlled through additional or enhanced mitigation measures. A cost-benefit analysis can assist in determining the mitigation measures in which to invest. Financial constraints and resource limitations may present challenges when looking to manage unacceptable risks. As a starting point, senior management may choose to initially focus mitigation measures on the most consequential risks and then control remaining risks as resources become available. In other instances, if the risks are determined to be too high or costly to mitigate, the organization’s project or program may need to be modified or cancelled. Recommendations for mitigation measures should be documented in the final report of the biosecurity risk assessment.

Through the sharing of experience of developed countries, which faced the massive health problem due to vehicular pollution in the past and remedial measures adopted by them, it is needed to avoid mistakes made in the past and instead introduce effective measures for the future to reduce or confine the damage that has already been incurred. A progressive policy of motor vehicle emission control strategy, which may be more feasible/affordable, has to be adopted for solving immediate air pollution problems. Uncontrolled growth of vehicular fleet and its emission is taking place in the urban areas, which must be controlled/regulated in order to prevent future disaster. Because of economic development and speed of motorization expected over next decades this problem will become more vulnerable and even greater, If control measure are not adopted timely. It is suggested that planning must begin to provide alternatives to the motor vehicles and to reduce emission of the vehicles. The country without high capital resources will face challenging problems for evolving control strategy that will be acceptable both economically and socially.

ABSTRACT

The potato is one of the most important food crops both in developed as well as in developing countries. Developing countries today produce 37 per cent of world’s output of potatoes. Potato is an important food crop in India. Both area under potato cultivation and production has increased manifolds during past decades. The efforts are being made to improve potato quality and its post harvest life as well.

An experiment was conducted to isolate mitochondria from potato tubers and succinate dehydrogenase (SDH) assay and protein profiling were performed in the tissue. Three varieties namely, Kufri Bahar, Kufri Lauvkar and Kufri Jyoti were taken into consideration for the present investigation. Kufri Bahar showed the minimum values for SDH activity and Kufri Jyoti the maximum SDH activity. On the basis of SDH activity, the mitochondria in Kufri Jyoti were seemed to be more viable, functional and coupled as compared to Kufri Bahar and Kufri Lauvkar. This finding also suggested that the respiratory degradation of starch in Kufri Jyoti was higher as compared to Kufri Bahar and Kufri Lauvkar. Thus these result showed that the shelf life of Kufri Jyoti was less as compared to Kufri Bahar and Kufri Lauvkar. Protein profiling performed by SDS-PAGE was found to be similar in all the potato tubers.

Abstract

Mitochondrial (mt) genomic study may reveal significant insight into the molecular evolution and several other aspects of genome evolution such as gene rearrangements evolution, gene regulation, and replication mechanisms. Other questions such as patterns of gene expression, mechanism of evolution, genomic variation and its correlation with physiology, and other molecular and biochemical mechanisms can be addressed by the mt genomics. Rare genomic changes have attracted evolutionary biology community for providing homoplasy free evidence of phylogenetic relationships. Gene rearrangements are considered to be rare evolutionary events and are being used to reconstruct the phylogeny of diverse group of organisms. Mitochondrial gene rearrangements have been established as a hotspot for the phylogenetic and evolutionary analysis of closely as well as distantly related organisms. This evolutionary episode has significant contribution among animals as well as plants and serves as an important genomic evolutionary event for the analysis of mitogenomes on large scale.

NEW CELLS ARE PRODUCED BY DIVISION OF PREVIOUSLY EXISTING CELLS

All cells come from previously existing cells

To make a new cell identical to itself a cell must perform 4 tasks:

It must grow and make additional copies of all its organelles, enzymes, etc..

It must duplicate its DNA

It must accurately separate the DNA into 2 units, so that each cell gets a full set

It must divide into 2 cells (cytokinesis)

Cells divide and reproduce in two ways: mitosis and meiosis.
Mitosis is a process of cell division that results in two genetically identical daughter cells developing from a single parent cell.
Meiosis, on the other hand, is the division of a germ cell involving two fissions of the nucleus and giving rise to four gametes, or sex cells, each possessing half the number of chromosomes of the original cell.Mitosis is used by single-celled organisms to reproduce; it is also used for the organic growth of tissues, fibers, and membranes. Meiosis is found in sexual reproduction of organisms. The male and female sex cells (i.e., egg and sperm) are the end result of meiosis; they combine to create new, genetically different offspring. 

The quality of ice cream depends on the balanced interaction of its major and minor constituents. This chapter examines ice cream mix as a multiphase system and explains the chemistry and functionality of its principal components. Milk fat, milk solids-not-fat, proteins, lactose, sugars, stabilizers, emulsifiers, water, and other constituents are considered in relation to body, texture, flavour, viscosity, freezing behaviour, and stability. The chapter also discusses minor milk constituents and the ways in which individual components interact rather than functioning independently. Understanding these relationships helps manufacturers identify formulation-related defects and optimize composition for desired sensory, processing, nutritional, and storage characteristics.

The selection and management of ingredients are fundamental to producing consistent, safe, and high-quality ice cream. This chapter provides an overview of the principal ingredients used in ice cream mixes and explains their selection criteria, approximate composition, functionality, storage requirements, and handling practices. It considers dairy ingredients, sweeteners, stabilizers, emulsifiers, flavours, colours, inclusions, and other formulation components. Ingredient quality directly influences processing performance, sensory properties, shelf life, and product cost. The chapter also highlights incoming-material quality checks and common ingredient-related defects. By understanding ingredient functionality and quality specifications, manufacturers can improve formulation accuracy, process consistency, product performance, and overall manufacturing efficiency.

Fermentation

The term fermentation is loosely used to denote any process in which microorganisms are involved, regards of whether or not the organism is growing in the presence of molecular oxygen. Thus, it can be defined as 'an ATP generating metabolic process in which organic compounds serve both as electron donor (becoming oxidized) and electron acceptor(becoming reduced). Energetically, fermentations are poor energy yielding process and products have lower energy content then the substrates. Since there is no net oxidation in fermentation, the number of molecules of C, H and O remain the same in products as in the substrate.

Mixed farming exists in many forms depending on external and internal factors. External factors are weather patterns, market prices, technological developments, etc. Internal factors relate to local soil characteristics, composition of the family and farmers’ ingenuity. Farmers can decide to opt for mixed enterprises when they want to save resources by interchanging them on the farm - because these permit wider crop rotations and thus reduce dependence on chemicals, because they consider mixed systems closer to nature, or because they allow diversification for better risk management. There is wide variation in mixed systems. Even pastoralists practice a form of mixed farming since their livelihood depends on the management of different feed resources and animal species. Mixed farms are systems that consist of different parts, which together should act as a whole. They thus need to be studied in their entirety and not as separate parts in order to understand the system and the factors that drive farmers and influence their decisions. It may be the most important principle to achieve increased production in mixed systems, together with the awareness that crops and animals have multiple functions.

Ingredient of 1kg mixed pickles: Cauliflower + diced carrot + turnip slice + vegetable pea each in equal amount of 1kg, salt 100g, ginger chopped 20g, onion chopped 50g, garlic chopped 10g, red chilli powder, black pepper, turmeric, cardamom large, aniseed powder, cumin, fenugreek powder each of 10g, clove headless 5 number and mustard 50g, vinegar 200 ml and mustard oil 450 ml.

The domestic electric food juicer/mixer/grinder has become an integral fixture in the typical modern kitchen. Generally functional as liquidizers, grinders and juicers, this paraphernalia comes in handy for grinding/pulverizing/powdering dry foodstuffs either raw or roasted (cereals, grains, masalas, coffee seeds, etc.), for mixing liquids and for converting food— with or without the presence of water (or vegetable oils)—into forms of slurry or pulps. It is also used for extracting juice from fruits or vegetables.

1. MIXING AND DIVIDING

The main objective of mixing and dividing of seeds is to obtain the representative homogenous seed sample for analysis by reducing the submitted sample to the desired size of working sample.

2. TYPES OF MECHANICAL DIVIDERS

2.1. Boerner divider

The principle involved in mixing and dividing in gravitational force. It consists of a hopper, a cone and series of baffles directing the seeds into 2 spouts. The baffles are of equal size and equally spaced and every alternate one leading to one spout. They are arranged in circle and are directed inward. A valve at the base of the hopper retains the seeds in the hopper. When the valve is opened, the seeds fall by gravity over the cone where it is equally distributed and approximately equal quantity of seeds will be collected in each spout. A disadvantage of this divider is that it is difficult to check for cleanliness (Fig. 1).

I. FILL UPS

1. _____ works on the principle based on gravitational force
2. Gamet divider is otherwise known as_____.
3. Gamet divider works on the principle based on_____.
4. _____ method is suitable for seeds requiring working samples upto 10grams and seeds not chaffy and do not bounce and roll.

1. Introduction

Mixing is a fundamental and widely practiced operation in many fields, such as chemical, pharmaceutical, and food processing industries. The mixture’s primary aim is to increase the homogeneity of the material in bulk (Uhl and Gray, 1986; Patterson et al., 2004). Mixing means the random distribution of two or more ingredients throughout a system, which differs from the term’ agitation,’ which is defined as establishing a particular flow pattern with the liquid, especially in a circulatory motion within a container. Mixing is a necessary step in the context of food processing operations. 

M-Agriculture

Mobile phones have changed the scenario of telecommunication. It is a source of communication for fast dissemination of information. Today, mobile usage has enabled farming communities to access agricultural and other business information without travelling long distances or reducing costs, time and money. Keeping in view the lower ratio of the farmer to the extension worker (1000: 1) and the inability of the extension workers to guide the farmers as per their information needs, the new concept of m-Agriculture (m-Krishi) has emerged at the beginning of twenty-first century all over the world including India.

Introduction In modern agriculture, soft resources like knowledge and skills are sometimes even more crucial than hard resources like inputs. In the 21st century, agriculture has to overcome a number of obstacles, including feeding an expanding population while a declining rural labour force, producing more feedstocks for a huge bioenergy market, supporting the overall development of many developing countries heavily dependent on agriculture, adopting more efficient and sustainable production techniques, and adapting to climate change (Colle, 2011). In order to make efficient and effective agricultural decisions, farmers are increasingly adopting information (Cash, 2001). Compared to the current availability of roughly 0.1 million personnel, the required number of extension agent who worked in field level is anticipated in between 1.3 to 1.5 million.

Introduction

Information technology is rapidly changing the use of Geographic Information Systems (GISs) from the classic desktop applications into the business service market. With the ubiquitous computing, the settings change dramatically and the classic GIS market will change drastically in the coming few years.

Till mid 90’s, the architecture of GIS focused on a standalone (static) environment. This architecture has been changed to move GIS applications from workstations into mobile GIS applications.

Mobile map applications is not a conventional GIS modified to operate on mobile devices, but a system build using a fundamentally new paradigm(Maguire,2001).

In this paper, we will discuss the integration of XML (eXtensible Markup Language) and J2ME (Java 2 Micro Edition) to build a mobile map application running on 2.5G and 3G mobile devices such as Nokia series 60.

Abstract

The chapter examines the relationship between the agricultural value chain and mobile apps. Using email survey data from mobile app developers, supplemented with basic desk research, the chapter reviews and analyzes 55 mobile apps based on their location within the value chain, the format of content delivery, the types of device used, the stage of deployment as of  2012, the type of business model used, and the geographic focus of the app. The analysis generally reveals an even distribution of apps within the three main components of the agricultural value chain but when it comes to the sub-categories within the agricultural value chain, skewed distribution was observed. Feature phones remain the dominant device for delivering agricultural information to users, however, increasing number of smartphone-specific applications gaining market. Most of the devices use text format for content delivery with voice, image and video as supplements.